Cars without BT module or Built-in BT module

Steering wheel control module 1K0 and 3C0
Locked
User avatar
Xhorse
Site Admin
Posts: 388
Joined: Fri Feb 24, 2017 4:12 pm
Contact:

Cars without BT module or Built-in BT module

Post by Xhorse »

Cars without BlueTooth module
For cars with RNS315, RNS510, RCD300, RCD310, RCD320 , Composit Media STD (5K7035200, MIB2 STD 5C0035680 US , EU, 5L0035680, RCD330

Check if your SWCM have proper PIN location
Image
If you have 5 or less , you need solder PINS from spare module (see picture below)
Image

Require SWCM(16) - LowLine
If you have HighLine - need to be recode to LowLine
If not support code to LowLine, please replace to LowLine or require EMULATOR and follow this manual

1) Recode SWCM to LowLine if need
Image

2) Install proper stalks
Image

If you have basic MFSW for MFA , keep circuit and keep use CCS indicator stalk

If you want operate CCS from MFSW install proper stalk
Image

3) Solder output wires depend of module type
Image
Image

4) solder input wires and cut 2 track (this is 2nd airbag tracks, not in use) NO NEED solder BLACK wire, due to GND is already in Airbag loom
Black wire is need only if you want test MFSW separate
Image
Blue resitor is ONLY for emulate 2nd airbag in Passat

ImageImage

5) After proper CAN installation and POWER connection RED led stay ON (go OFF after Ignition OFF). When you connect MFSW over LIN wire WHITE LED start flashing, when you press CCS button (CCS is ON) , Green LED start illuminate, when module is working RED led illuminate, when module go to “sleep” RED and other led's are OFF
Image

6) After proper connection you should see new module (3D) in Can Gateway list , please "register" it on Gateway Instalation list

7) Check and change if need Airbag loom
Image

2 samples of genuine MFSW loom after changes
Image
Image

Locked

Who is online

Users browsing this forum: No registered users and 1 guest